V-belt Movendis PP-XPA1107-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- XPA
- Series
- PowerPlus EPDM Cogged Raw Edge Narrow
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-XPA1107-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-XPA1107-EPDM-AS and any equivalents.
This Movendis PowerPlus EPDM Cogged Raw Edge Narrow belt is a cogged narrow V-belt in the XPA profile with a length of 1107 mm. It is built for industrial drives that call for a narrow wedge belt where the original specification is a cogged raw edge construction.
Cogged narrow V-belts are used on compact, high-ratio drives where standard-section belts would be too wide or too heavy. Typical industrial settings include pumps, fans, compressors, blowers, mixers and machine tools. The XPA profile and the 1107 mm length are the two dimensions to confirm before ordering.
To verify fit, read the marking on the back of the old belt and match the profile and length. If the belt is worn or unmarked, measure the outside length and the top width, and note the pulley groove dimensions. Send the part number PP-XPA1107-EPDM-AS, or your measurements, by WhatsApp or email and we will help confirm the right belt or suggest an equivalent.
When replacing a set, fit all belts on the same drive at the same time so the load stays even across the grooves. Check pulley alignment and groove wear before installation, and set tension to the drive manufacturer's specification. Inspect the belt after the first run-in period and retension if needed.
Dimensions
- Section
- XPA
- Length
- 1107mm
Frequently asked questions
- How do I confirm this belt fits my drive?
- Match the profile and length: XPA profile, 1107 mm. Check the marking on the old belt, or measure the outside length and top width. If you are unsure, send the part number or your measurements and we will help confirm the right belt.
- Can this belt be used on any XPA drive?
- It fits drives that specify an XPA profile belt with a 1107 mm length. The drive's pulley grooves and the required belt construction must also match. When in doubt, request a quote by part number and our team will confirm.
- What should I send for a quote?
- Send the part number PP-XPA1107-EPDM-AS, or the profile and length from the old belt, along with the quantity you need. If you have the drive make and model, include that as well. We reply by WhatsApp or email.