V-belt Movendis PP-SPB4000
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPB
- Series
- PowerPlus Narrow Wedge V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-SPB4000 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-SPB4000 and any equivalents.
The Movendis PP-SPB4000 is an SPB profile narrow wedge V-belt with a 4000 mm length. It is part of the PowerPlus line and carries a 40-degree angle, 16.3 mm top width and 13 mm height. Use these figures to match it against the belt you are replacing.
Start by reading the marking on the back of the old belt. Confirm the profile is SPB and the length is 4000 mm, then check the top width and height against the 16.3 mm and 13 mm listed here. A belt that has worn or stretched can measure short of its original length, so compare the printed code first and treat a tape measurement as a secondary check.
The 40-degree angle and narrow wedge construction are part of the SPB profile, so a pulley cut for SPB sections is what this belt is built to run in. Inspect the drive while the belt is off: look for worn pulley grooves, sheave misalignment, oil or debris in the grooves, and any damaged or seized idler. Correcting those before fitting a new belt helps the replacement run true.
If you are replacing more than one belt on a multi-belt drive, order the full set at the same time so the belts share the same profile and length. Send the part number PP-SPB4000, the quantity, and the drive details by WhatsApp or email and the team will confirm the belt or suggest an equivalent.
Dimensions
- Section
- SPB
- Length
- 4000mm
Frequently asked questions
- How do I confirm the PP-SPB4000 matches the belt I am removing?
- Check the old belt's back marking for SPB and 4000 mm, then compare its top width and height to the 16.3 mm and 13 mm of the PP-SPB4000. If the marking is unreadable, measure the outside length and section and send those figures with your request.
- What should I send to get a quote for this belt?
- Send the part number PP-SPB4000, the quantity you need, and the drive or equipment it fits. Photos of the old belt marking and the pulley grooves help the team confirm the correct item or propose an equivalent.
- Can I order a matched set of these belts?
- Yes. State the number of belts the drive uses when you request a quote so the set is supplied together with the same SPB profile and 4000 mm length.