V-belt Movendis PP-SPB2000
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPB
- Series
- PowerPlus Narrow Wedge V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-SPB2000 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-SPB2000 and any equivalents.
The Movendis PP-SPB2000 is a narrow wedge V-belt in the SPB profile with a 2000 mm length. It is built for drives that run SPB-section belts, with a 16.3 mm top width, 13 mm height and 40 degree angle. We carry it for maintenance and replacement work.
The most reliable way to match this belt is to read the marking on the belt you are replacing. Look for the profile and the length, not just the part number. If the old belt shows SPB and 2000 mm, the PP-SPB2000 is the correct section and length. Confirm the top width and height against the worn belt before ordering.
Narrow wedge belts like this one run in smaller, lighter drives than classic V-belts of the same power capacity. When a belt has stretched, cracked or worn to the point where it no longer grips, replace it rather than trying to re-tension it. On a multi-belt drive, fit a full set of belts from the same production so the load is shared evenly.
For a quote, send the part number PP-SPB2000, or send the marking from your old belt and a photo of the drive. Our team can confirm the SPB profile and 2000 mm length and suggest an equivalent if needed.
Dimensions
- Section
- SPB
- Length
- 2000mm
Frequently asked questions
- How do I confirm this is the right belt for my drive?
- Check the marking on the belt you are replacing. It should show the SPB profile and a 2000 mm length. You can also measure the top width and height of the old belt and compare them with the 16.3 mm top width and 13 mm height of the PP-SPB2000.
- Can I replace just one belt on a multi-belt drive?
- On a drive that uses several belts, it is best to replace them as a set. Belts wear and stretch at different rates, so mixing a new belt with old ones can cause uneven loading. Order the number of belts the drive requires.
- What information should I send for a quote?
- Send the part number PP-SPB2000, or send the full marking from your old belt along with a photo of the drive. If the marking is worn, note the profile and length you measured. We will confirm the belt and reply by WhatsApp or email.