V-belt Movendis PP-CX97-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- CX
- Series
- PowerPlus EPDM Cogged Raw Edge Classical
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-CX97-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-CX97-EPDM-AS and any equivalents.
The Movendis PP-CX97-EPDM-AS is a cogged classical V-belt in the CX profile with a length of 2520 mm. Before you fit it, take a few minutes to inspect the drive and sheaves so the new belt runs true from the start.
Check each sheave groove for wear, burrs, or embedded debris. A worn groove lets the belt sit too deep and slip; a rough groove can cut the cover. Confirm the sheaves are aligned and the shafts turn freely. Look at the old belt for uneven edge wear or glazing, since those signs often point back to the drive rather than the belt.
Set the correct tension after installation, then recheck it once the drive has run under load. On multi-belt drives, replace all belts as a set so the load stays even across the grooves. Keep the sheaves clean and dry, and confirm nothing rubs the belt along its route.
For a quote, send the part number PP-CX97-EPDM-AS by WhatsApp or email. If you are matching an old belt, include the full marking from the back of the belt and the drive details. The team can confirm the CX profile and 2520 mm length or suggest an equivalent.
Dimensions
- Section
- CX
- Length
- 2520mm
Frequently asked questions
- What should I check on the drive before fitting this belt?
- Inspect sheave grooves for wear, burrs, and debris, confirm alignment, and make sure the shafts turn freely. Correct any drive problem first so the new belt is not damaged on start-up.
- How do I identify the belt I need?
- Use the marking on the back of the old belt. This belt is the Movendis PP-CX97-EPDM-AS, CX profile, 2520 mm. Send that marking or the part number for confirmation.
- Should I replace all belts on a multi-belt drive at once?
- Yes. Replacing the full set keeps tension and load sharing even across the grooves. Mixing a new belt with worn ones can overload the new belt.