V-belt Movendis PP-CX95,5-EPDM-AS

MOVENDIS PP-CX95,5-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-CX95,5-EPDM-AS and any equivalents.

The marking on the back of an old belt is often the fastest way to identify its replacement. This page covers the Movendis PP-CX95,5-EPDM-AS, a cogged classical V-belt in the CX profile with a length of 2482 mm. Use the steps below to read your existing belt and confirm this part number before requesting a quote.

Start by locating the printed code on the back of the belt. It may be partly worn, so clean the surface and read in good light. The code you are looking for is PP-CX95,5-EPDM-AS. The CX profile and 2482 mm length are the two dimensions to match. If the old marking is unreadable, measure the outside length and compare it to the 2482 mm figure, and note the top width and thickness of the belt cross-section.

This Movendis belt is a cogged classical V-belt from the PowerPlus EPDM Cogged Raw Edge Classical series. Cogged construction is common on drives with small pulleys, where a raw edge profile can run cooler and resist slipping. When you replace a belt, inspect the pulleys for wear, alignment and debris, and check that the belt sits correctly in the groove. If the drive uses multiple belts, replace them as a set so the load stays even.

To request a quote, send the part number PP-CX95,5-EPDM-AS by WhatsApp or email. If you are unsure whether this is the correct belt, include a photo of the old marking and the drive setup. The team can confirm the right belt or suggest an equivalent based on the code you provide.