V-belt Movendis PP-CX43-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- CX
- Series
- PowerPlus EPDM Cogged Raw Edge Classical
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-CX43-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-CX43-EPDM-AS and any equivalents.
The Movendis PP-CX43-EPDM-AS is a cogged classical V-belt in the CX profile with a length of 1148 mm. The marking on the belt gives you the two facts that matter most when ordering: the cross-section and the length.
Profile and length are the starting point for any replacement. The CX profile sets the cross-section that has to sit correctly in the pulley groove, and 1148 mm is the datum length you match against the belt you are replacing. Read both directly off the old belt before you order, since the part number on the back is the surest way to confirm you are looking at the same belt.
The cogged construction is molded into the underside of the belt, which is typical of raw edge classical belts built to run over smaller pulleys. This is a classical V-belt rather than a narrow wedge, so the groove width it fits differs from a wedge belt of similar top width.
Send us the part number PP-CX43-EPDM-AS, or the profile and length from the old belt, by WhatsApp or email and we will confirm the belt or suggest an equivalent. Photos of the back marking and the pulley groove help us get it right the first time. If a drive runs more than one belt, order the full set so the belts share the load evenly.
Dimensions
- Section
- CX
- Length
- 1148mm
Frequently asked questions
- What do the CX profile and 1148 mm length tell me?
- The CX profile sets the cross-section that must match the pulley groove, and 1148 mm is the length to match against the belt being replaced. Both appear in the marking and in the part number PP-CX43-EPDM-AS.
- How do I confirm this is the right belt before ordering?
- Read the marking on the back of the old belt and compare the profile and length. Send the part number PP-CX43-EPDM-AS, or the profile and length, by WhatsApp or email and we will confirm it or suggest an equivalent.
- Should I replace all the belts on a multi-belt drive at once?
- Yes. On a drive running more than one belt, replacing the full set keeps tension and load sharing even, which is why we recommend ordering the complete set rather than a single belt.