V-belt Movendis PP-CX30-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- CX
- Series
- PowerPlus EPDM Cogged Raw Edge Classical
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-CX30-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-CX30-EPDM-AS and any equivalents.
The Movendis PP-CX30-EPDM-AS is a cogged classical V-belt in the CX profile with an 818 mm length. Cogged classical belts are commonly used on drives with small pulleys or where a standard wrapped belt runs hot, and the raw-edge construction is typical of that service. Confirm the profile and length against your drive before ordering.
To check fit, read the marking on the back of the old belt and compare it with the CX profile and 818 mm length shown here. If the old belt is worn or the marking is unreadable, measure the outside length and the top width, and note the pulley groove dimensions. The CX profile and 818 mm length are the two values that must match.
Inspect the drive while the belt is off. Look for worn or misaligned pulleys, damaged grooves, and any signs of oil or heat that may have shortened belt life. Replace belts in sets when the drive uses more than one belt, so the load stays evenly distributed. After installation, check tension and recheck it after the first run-in period.
Dimensions
- Section
- CX
- Length
- 818mm
Frequently asked questions
- What do I need to send to request a quote for this belt?
- Send the part number PP-CX30-EPDM-AS, or the profile CX and length 818 mm, by WhatsApp or email. If you are replacing an existing belt, include the marking from the back of the old belt and the drive details so we can confirm the right belt.
- How can I confirm the CX profile and 818 mm length are correct for my drive?
- Compare the CX profile and 818 mm length with the marking on your old belt. If the marking is not readable, measure the top width and outside length of the old belt and check the pulley groove dimensions. The profile and length must match the drive.
- Is this belt suitable for drives that use multiple belts?
- This is a single cogged classical V-belt. On drives that use more than one belt, replace all belts in the set at the same time so they share the load evenly. Confirm the required number of belts and the profile and length for your drive.