V-belt Movendis PP-AX94-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- AX
- Series
- PowerPlus EPDM Cogged Raw Edge Classical
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-AX94-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-AX94-EPDM-AS and any equivalents.
When a drive goes down, the fastest way to the right replacement is the marking printed on the back of the old belt. This Movendis belt is a cogged classical V-belt in the AX profile, 2425 mm long, from the PowerPlus EPDM Cogged Raw Edge Classical series. Read the number off the belt and send it to us for a quote.
Start at the belt itself. The back of a cogged classical V-belt carries its profile and length, and that marking is what identifies the replacement. Look for the AX profile and the 2425 mm length, then match them against the part number you need. If the printing has worn away, measure the belt and photograph the drive so we can help confirm the profile and length.
The AX profile is a narrow cross-section, and 2425 mm is the datum length of this belt. Cogged raw edge construction is used where the belt bends over smaller pulleys, so check the pulley grooves and the condition of the sheaves while you have the drive open. A worn groove can shorten belt life even when the replacement is correct.
Replacement is straightforward once the marking is confirmed. Slacken the drive, remove the old belt without prying it over the pulley flange, fit the new one, and re-tension to the drive manufacturer's specification. On multi-belt drives, fit the full set at the same time so the load stays even across all belts.
Dimensions
- Section
- AX
- Length
- 2425mm
Frequently asked questions
- How do I identify the belt I need?
- Read the marking on the back of the old belt. The profile and length are printed there, and for this belt they are AX and 2425 mm. Send those details, or the part number, and we will quote the matching Movendis belt.
- What if the marking on my old belt is unreadable?
- Measure the outside length and the top width, and take a photo of the belt and the drive pulleys. With the profile and length we can confirm the correct belt, such as this AX profile, 2425 mm Movendis.
- Should I replace all belts on the drive at once?
- On a multi-belt drive, yes. Belts that have run together take a set, so mixing a new belt with old ones can leave the new belt carrying more than its share of the load. Fit a matched set and re-tension to the drive specification.