V-belt Movendis PP-AX67,5-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- AX
- Series
- PowerPlus EPDM Cogged Raw Edge Classical
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-AX67,5-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-AX67,5-EPDM-AS and any equivalents.
The Movendis PP-AX67,5-EPDM-AS is a cogged classical V-belt in the AX profile with a length of 1752 mm. Cogged classical belts are used on industrial drives where a standard classical section is required and the raw-edge cogged construction suits smaller pulleys or higher-speed operation. This page covers how to confirm the belt fits your drive before you order.
To confirm fit, read the marking on the back of the belt you are replacing and match the profile and length. The AX profile is a classical V-belt section, and the 1752 mm length is the datum length for this belt. If the old belt is worn or the marking is unreadable, measure the outside length and the top width, and note the pulley groove dimensions.
Also check the drive itself: pulley groove condition, alignment, and the number of belts on the drive. If the drive runs multiple belts, replace them as a set so the load is shared evenly. A cogged belt can run on smaller pulleys than a wrapped belt of the same section, but the pulley must still be within the correct range for the AX profile.
Dimensions
- Section
- AX
- Length
- 1752mm
Frequently asked questions
- How do I confirm the Movendis PP-AX67,5-EPDM-AS fits my drive?
- Match the AX profile and the 1752 mm length to the marking on your existing belt. If the marking is gone, measure the outside length and top width and compare them with the drive specification.
- Can I replace just one belt on a multi-belt drive?
- On a drive with two or more belts, replace the full set at the same time. Mixing a new belt with worn belts can cause uneven tension and load sharing.
- What should I send to request a quote?
- Send the part number PP-AX67,5-EPDM-AS, the quantity, and the drive details if you have them. If you are unsure of the part number, send the marking from the old belt or the profile and length.