V-belt Movendis PP-AX55-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- AX
- Series
- PowerPlus EPDM Cogged Raw Edge Classical
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-AX55-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-AX55-EPDM-AS and any equivalents.
The Movendis PP-AX55-EPDM-AS is a cogged classical V-belt in the AX profile with a length of 1434 mm. Before you fit it, inspect the drive and sheaves so the new belt runs true from the start.
Check sheave grooves for wear, burrs, or debris that can cut a belt or make it sit high. Confirm the sheaves are aligned and the shafts turn freely. If the old belt failed early, the drive usually shows why.
Measure the old belt and compare it with the 1434 mm length and AX profile of the PP-AX55-EPDM-AS. A worn belt can measure short, so read the marking on the back of the old belt when possible. If the number is unreadable, send photos of the drive and the old belt for confirmation.
When you replace a belt on a multi-belt drive, fit the full set at the same time so the load stays even. Tension the new belt to the drive maker's specification, then recheck after the first run-in.
Dimensions
- Section
- AX
- Length
- 1434mm
Frequently asked questions
- What should I check on the drive before fitting this belt?
- Inspect sheave grooves for wear, burrs, or debris, confirm alignment, and make sure the shafts turn freely. Correct any issue before the new belt goes on.
- How do I confirm the PP-AX55-EPDM-AS is the right belt?
- Match the AX profile and the 1434 mm length against the old belt or the drive marking. If the old marking is gone, send photos of the drive and belt for us to check.
- Should I replace all belts on the drive at once?
- Yes. On a multi-belt drive, fit a full set so the load is shared evenly, then tension to the drive maker's specification and recheck after run-in.