V-belt Movendis PP-AX42-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- AX
- Series
- PowerPlus EPDM Cogged Raw Edge Classical
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-AX42-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-AX42-EPDM-AS and any equivalents.
The Movendis PP-AX42-EPDM-AS is a cogged classical V-belt in the AX profile with a length of 1104 mm. It belongs to the PowerPlus EPDM Cogged Raw Edge Classical series. To match it to the belt being replaced, read the marking on the back of the old belt and compare profile, length and construction.
Start with the profile. The AX profile is a classical V-belt cross-section, and this belt is cogged with a raw edge. If the old belt shows AX and a length close to 1104 mm, this part is the direct size match. If the old belt is not marked, measure the outside length and compare it to the 1104 mm listed here, and confirm the cross-section against the pulley groove.
Cogged raw edge construction is used where the belt must run over smaller pulleys or handle higher speeds than a wrapped belt of the same profile. The EPDM compound in this series is intended for industrial drive service. When you replace a belt, inspect the pulleys for wear, alignment and debris, and check that the take-up is within range before fitting the new belt.
If a drive uses multiple belts, replace them as a set so the load is shared evenly. Send the part number PP-AX42-EPDM-AS, or the full marking from the old belt, by WhatsApp or email for a quote. If the exact marking is unreadable, send the profile, the length and a photo of the belt and the drive, and we can help confirm the right belt or suggest an equivalent.
Dimensions
- Section
- AX
- Length
- 1104mm
Frequently asked questions
- How do I confirm this belt matches the one I am replacing?
- Read the marking on the back of the old belt. You need the profile (AX) and the length (1104 mm). If the old belt matches both, this Movendis PP-AX42-EPDM-AS is the same size. If the marking is worn off, measure the outside length and check the cross-section against the pulley groove.
- What should I send to get a quote?
- Send the part number PP-AX42-EPDM-AS, or the complete marking from the old belt, by WhatsApp or email. If you do not have the marking, send the profile, the length and a photo of the belt and the drive.
- Should I replace all belts on a multi-belt drive at once?
- Yes. On a drive that uses more than one belt, replace the full set together so the belts share the load evenly. Mixing new and used belts can cause the new belt to carry more than its share.