V-belt Movendis PP-AX35,5-EPDM-AS
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- AX
- Series
- PowerPlus EPDM Cogged Raw Edge Classical
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS PP-AX35,5-EPDM-AS belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PP-AX35,5-EPDM-AS and any equivalents.
The Movendis PP-AX35,5-EPDM-AS is a cogged classical V-belt in the AX profile with a 939 mm length. Before fitting it, inspect the drive and sheaves so the new belt runs true from the start.
Check sheave grooves for wear, rust, burrs or embedded debris. Worn grooves let a new belt sit too deep and slip. Confirm the sheaves are aligned and the correct AX profile is called for. Spin the drive by hand and check bearings and shafts.
Once the drive checks out, fit the PP-AX35,5-EPDM-AS and tension it to the drive maker's specification. Recheck tension after the first run-in period. If the drive uses multiple belts, replace them as a set so load stays even across all belts.
For a quote, send the part number PP-AX35,5-EPDM-AS and the quantity you need. If you are unsure the AX profile and 939 mm length match your drive, send a photo of the marking on the back of the old belt and we will help confirm the right belt.
Dimensions
- Section
- AX
- Length
- 939mm
Frequently asked questions
- What is the profile and length of this belt?
- It is an AX profile cogged classical V-belt with a length of 939 mm.
- How do I request a quote?
- Send the part number PP-AX35,5-EPDM-AS and your quantity by WhatsApp or email. We reply promptly.
- What should I check before fitting this belt?
- Inspect sheave grooves for wear or damage, confirm alignment, and check bearings and shafts. Then fit the belt and tension it to the drive maker's specification.