V-belt Movendis P-Z67
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- Z
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-Z67 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-Z67 and any equivalents.
If you are replacing a worn classical V-belt, the most reliable starting point is the marking on the old belt. The Movendis P-Z67 is a classical wrapped V-belt in the Z profile with a length of 1700 mm. Match those two values to the belt you are removing before you request a quote.
The P-Z67 is built for drives that use a classical V-belt cross section. The Z profile identifies the cross section, and 1700 mm is the length. When you inspect the old belt, look for a legible part number on the back. If it reads P-Z67, this is the same belt. If the number is worn away, measure the outside length and compare it to 1700 mm, and confirm the cross section is Z.
A Z profile belt will not seat correctly in a pulley cut for another cross section, so profile and length both matter. Do not substitute a belt that only matches one of the two. If the drive uses multiple belts, replace them as a set so the load stays even across the grooves. Check the pulleys for wear, oil or debris while the belt is off.
To request a quote, send the part number P-Z67 by WhatsApp or email. If you are unsure whether it matches your drive, include the marking from the old belt, the profile and the length you measured. The team can confirm the P-Z67 or suggest the correct alternative.
Dimensions
- Section
- Z
- Length
- 1700mm
Frequently asked questions
- How do I confirm the P-Z67 matches the belt I am replacing?
- Check the marking on the back of the old belt. If it reads P-Z67, it is the same belt. If the marking is unreadable, confirm the profile is Z and the length is 1700 mm.
- What should I send with my quote request?
- Send the part number P-Z67. If you are not certain, include the old belt marking, the profile and the length you measured so the team can confirm it.
- Should I replace all belts on a multi-belt drive at once?
- Yes. Replacing the full set helps keep tension and load even across the grooves, which supports consistent drive performance.