V-belt Movendis P-Z49
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- Z
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-Z49 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-Z49 and any equivalents.
The Movendis P-Z49 is a classical wrapped V-belt with a Z profile and a length of 1245 mm. Before you fit it, take a few minutes to inspect the drive and sheaves. A worn or misaligned groove will shorten the life of any new belt.
Check the sheave grooves for wear, rust, and buildup. A groove that has worn wider lets the belt sit too deep, so it slips and runs hot. Look at both flanges for a lip or step, and confirm the grooves are clean and dry. If one sheave is badly worn, a new belt will not seat correctly and will wear quickly.
Align the sheaves with a straightedge across the faces. Misalignment pulls the belt to one side and can roll it out of the groove under load. Check the bearings for play and the shaft for movement; any wobble will show up as vibration and edge wear. Tension the P-Z49 according to your drive requirements, then recheck after the first run-in period.
When you are ready to order, send the part number P-Z49, the quantity, and any details about the drive. We carry the Movendis classical wrapped V-belt line and can confirm the Z profile and 1245 mm length against your application. If you are replacing a set, include the number of belts on the drive so we can help you match them.
Dimensions
- Section
- Z
- Length
- 1245mm
Frequently asked questions
- What should I check on the drive before installing a P-Z49?
- Inspect the sheave grooves for wear, rust, and buildup, and check alignment with a straightedge. Also check bearings for play and shafts for movement. Correct any issues before fitting the new belt.
- How do I identify the belt I need?
- Read the marking on the back of the old belt. The P-Z49 is a Z profile belt with a length of 1245 mm. If the marking is worn, measure the length and note the profile from the sheave groove.
- What information should I send for a quote?
- Send the part number P-Z49, the quantity, and any details about the drive or the old belt. If you are replacing a set, include the number of belts so we can help you match them.