V-belt Movendis P-SPB7500
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPB
- Series
- Narrow Wedge V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-SPB7500 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-SPB7500 and any equivalents.
Replacing a narrow wedge V-belt starts with the marking on the back of the old belt. The Movendis P-SPB7500 is an SPB profile belt with a 7500 mm length, a 16.3 mm top width, a 13 mm height and a 40 degree angle. Confirm each of those figures against the belt you are removing before you order.
Read the old belt first. Look for the profile, the length and the part number printed on the back. If the marking matches SPB and 7500 mm, the P-SPB7500 is the direct match. If the marking is worn or unreadable, measure the top width and the outside length with the belt laid flat and compare them to the 16.3 mm top width and 7500 mm length listed here.
The profile and the length are the two figures that decide fit. An SPB profile belt seats in an SPB groove, and the 40 degree angle is the flank angle that contacts the pulley. A belt with the same length but a different profile will not sit correctly in the groove, and a belt with the same profile but a different length will not tension properly. Check both before you install.
Inspect the drive while the belt is off. Look at the pulley grooves for wear or damage, check the alignment of the sheaves, and confirm the tensioning arrangement moves freely. If the drive runs more than one belt, replace the full set so the load is shared evenly across all belts. Send the part number, the profile and the length when you request a quote.
Dimensions
- Section
- SPB
- Length
- 7500mm
Frequently asked questions
- How do I confirm the P-SPB7500 is the right belt?
- Check the marking on the back of the belt you are replacing. It should show the SPB profile and a 7500 mm length. You can also measure the top width and compare it to the 16.3 mm listed for this belt.
- What should I send to request a quote?
- Send the part number P-SPB7500, or the profile and length from the old belt. A photo of the marking on the back of the belt also helps us confirm the match.
- Should I replace more than one belt at a time?
- If the drive uses a set of belts, replace the whole set together. Belts that have run for different lengths of time can tension unevenly and wear faster.