V-belt Movendis P-SPB3200

MOVENDIS P-SPB3200 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-SPB3200 and any equivalents.

The Movendis P-SPB3200 is a narrow wedge V-belt in the SPB profile, with a 3200 mm length, 16.3 mm top width, 13 mm height and a 40-degree angle. Before fitting this belt, inspect the drive and sheaves so the new belt seats and wears correctly. We carry this belt and quote by part number.

Start with the sheaves. Check groove wear, cracks, and any buildup, because worn or damaged grooves can let a new belt sit too deep or slip. Confirm the sheave groove angle and width suit the SPB profile, and make sure the sheaves are aligned so the belt runs straight. With the correct 3200 mm length and 16.3 mm top width, the belt should sit in the groove without bottoming out.

Inspect the rest of the drive as well. Look at the shafts, bearings, and tensioning system for play or roughness, and clean the grooves before installation. Set tension according to the drive maker's instructions, then recheck after the first run-in period. A 40-degree angle and 13 mm height are part of the SPB profile, so match the replacement to the same profile and length.

For a quote, send the part number P-SPB3200 and the quantity you need. If you are replacing a belt on a drive that has been modified or if the old belt marking is unreadable, send a photo of the drive and the old belt so we can help confirm the right belt or suggest an equivalent. We reply promptly by WhatsApp or email.