V-belt Movendis P-SPA857
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPA
- Series
- Narrow Wedge V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-SPA857 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-SPA857 and any equivalents.
The Movendis P-SPA857 is a narrow wedge V-belt in the SPA profile, with a length of 857 mm, a top width of 12.7 mm, a height of 10 mm and a 40-degree angle. Before you fit it, take a few minutes to inspect the drive and sheaves so the new belt seats and runs as intended.
Check the sheave grooves for wear, scoring, rust or embedded debris, and confirm the grooves match the SPA profile. Look for a step or ridge in the groove that would keep the belt from sitting at the correct depth. Spin the sheaves by hand and feel for rough or noisy bearings, and verify that the shafts are aligned and the sheaves are tight.
Compare the old belt against the marking on its back and confirm the profile and length. The P-SPA857 is an SPA profile belt, 857 mm long, 12.7 mm across the top, 10 mm high and with a 40-degree angle. If the drive uses more than one belt, replace the full set so the load stays even across the grooves.
To request a quote, send the part number P-SPA857 by WhatsApp or email. If you are unsure whether this is the right belt for your drive, include the drive details and a photo of the marking on the old belt, and the team can help confirm the correct belt.
Dimensions
- Section
- SPA
- Length
- 857mm
Frequently asked questions
- What should I check on the drive before fitting the P-SPA857?
- Inspect the sheave grooves for wear, scoring, rust or debris, confirm the grooves are correct for the SPA profile, check the bearings for roughness or noise, and verify shaft alignment and sheave tightness.
- How do I confirm the P-SPA857 matches the belt I am replacing?
- Read the marking on the back of the old belt and compare the profile and length. The P-SPA857 is an SPA profile belt with a length of 857 mm, a top width of 12.7 mm, a height of 10 mm and a 40-degree angle.
- What do I send to get a quote for the P-SPA857?
- Send the part number P-SPA857 by WhatsApp or email. If you need help confirming the belt, include the drive details and a photo of the marking on the old belt.