V-belt Movendis P-SPA647
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPA
- Series
- Narrow Wedge V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-SPA647 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-SPA647 and any equivalents.
The Movendis P-SPA647 is a narrow wedge V-belt in the SPA profile, with a 647 mm length. It is built to the 12.7 mm top width, 10 mm height and 40° angle shown in the data. Use those four values to match it to the belt you are replacing.
Start with the belt on the drive. Read the marking on the back: profile SPA and length 647 mm. Then check the dimensions against the data here. The top width is 12.7 mm, the height is 10 mm and the angle is 40°. If all of these agree, the P-SPA647 is the correct size for that position.
If the old belt is worn or the marking is gone, measure it off the drive. Confirm the profile first, then the length. A belt that is close in length but not in profile will not sit correctly in the pulley groove. For a quote, send the part number P-SPA647 or the profile and length.
Narrow wedge V-belts are used on industrial drives where a compact cross-section is needed. This belt is a single belt, not a banded set. When a drive uses more than one belt, replace the full set at the same time so the belts share the load evenly.
Dimensions
- Section
- SPA
- Length
- 647mm
Frequently asked questions
- How do I confirm the P-SPA647 is the right belt?
- Check the marking on the belt you are replacing for SPA and 647 mm. Then compare the top width (12.7 mm), height (10 mm) and angle (40°) with the data for this belt. If they match, it is the correct size.
- What should I send to request a quote?
- Send the part number P-SPA647, or the profile and length from the old belt. A photo of the back marking also helps confirm the profile and length.
- Should I replace all belts on a multi-belt drive at once?
- Yes. On a drive that uses more than one belt, replace the full set together so the belts are matched and wear evenly.