V-belt Movendis P-SPA2057
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPA
- Series
- Narrow Wedge V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-SPA2057 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-SPA2057 and any equivalents.
The Movendis P-SPA2057 is a narrow wedge V-belt in the SPA profile, with a 2057 mm length, 12.7 mm top width, 10 mm height and 40 degree angle. Before you fit it, check the drive and sheaves so the new belt runs true from the start.
Inspect sheave grooves for wear, burrs and embedded debris, and confirm the grooves match the SPA profile. Check pulley alignment and shaft play, and look for oil, heat or belt residue that points to a drive problem. Correcting these before installation helps the belt seat evenly and avoids repeat failures.
The P-SPA2057 carries a 2057 mm length, 12.7 mm top width, 10 mm height and 40 degree angle. If you are replacing an existing belt, read the marking on the back and match the profile and length before ordering. Send the part number P-SPA2057 by WhatsApp or email and we will confirm the belt or suggest an equivalent.
On multi-belt drives, replace the full set at the same time so matched belts share the load. After fitting, recheck tension and alignment, then inspect again after the first run-in period. Keep the old belt marking on file for the next replacement.
Dimensions
- Section
- SPA
- Length
- 2057mm
Frequently asked questions
- What should I check on the drive before fitting the P-SPA2057?
- Inspect sheave grooves for wear, burrs and debris, confirm the SPA profile matches, and check pulley alignment and shaft play. Also look for oil, heat or belt residue that indicates a drive problem.
- How do I confirm the P-SPA2057 is the right belt?
- Read the marking on the back of the old belt and match the profile and length. The P-SPA2057 has an SPA profile, 2057 mm length, 12.7 mm top width, 10 mm height and 40 degree angle.
- Should I replace all belts on a multi-belt drive at once?
- Yes. Replace the full set at the same time so the belts share the load evenly, then recheck tension and alignment after run-in.