V-belt Movendis P-D441
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- D
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-D441 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-D441 and any equivalents.
The Movendis P-D441 is a classical wrapped V-belt with a D profile and a length of 11200 mm. To match it to the belt you are replacing, confirm both the profile letter and the length from the old belt's back marking. This page covers what to check before you request a quote.
Start with the marking on the back of the belt being replaced. The profile is D and the length is 11200 mm. If the old belt is worn or the marking is gone, measure the outside length and compare it to 11200 mm, and confirm the cross-section matches the D profile. A belt that is too short or too long will not tension correctly, and a different profile will not sit properly in the pulley groove.
When the profile and length match, the P-D441 is the correct replacement for that drive position. Inspect the pulleys for wear, alignment, and debris before installing the new belt. On drives with multiple belts, replace all belts in the set at the same time so the load is shared evenly.
We carry the Movendis P-D441 for maintenance, engineering, and purchasing teams. Send the part number, the profile, and the length by WhatsApp or email to request a quote. If you are unsure of the profile or length, include a photo of the back marking and the pulley grooves so we can help confirm the right belt.
Dimensions
- Section
- D
- Length
- 11200mm
Frequently asked questions
- How do I confirm the P-D441 matches the belt I am replacing?
- Check the back of the old belt for the profile and length. The P-D441 is a D profile belt with a length of 11200 mm. If the marking is unreadable, measure the outside length and compare it to 11200 mm.
- What should I send to request a quote for the P-D441?
- Send the part number P-D441, along with the profile and length if you have them. A photo of the old belt's back marking and the pulley grooves helps us confirm the match.
- Should I replace all belts on the drive at once?
- Yes. On drives that use multiple belts, replace the full set at the same time so each belt carries an equal share of the load. Mixing new and worn belts can cause uneven tension and premature failure.