V-belt Movendis P-D326
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- D
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-D326 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-D326 and any equivalents.
The Movendis P-D326 is a classical wrapped V-belt in the D profile with a length of 8280 mm. The profile and length are the two figures that matter most when you are matching a belt to an existing drive. This page gives you those values directly so you can confirm the belt before you request a quote.
In a classical wrapped V-belt, the profile sets the cross-section that must sit correctly in the pulley groove. The D profile is the section to check against your drive's sheave dimensions. The length of 8280 mm is the second control point: a belt that is too short or too long will not tension correctly, so compare this figure with the belt you are replacing.
The cleanest way to confirm a replacement is to read the marking on the back of the old belt. If P-D326 or the D profile and 8280 mm length match what you find, send that part number to us by WhatsApp or email. If the marking is worn or the belt is missing, send the profile and the measured length instead, and our team will help confirm the right belt.
For drives that run more than one belt, inspect the full set before ordering. Belts that have run together wear together, and replacing only part of a set can leave the drive unevenly loaded. Note the quantity you need along with the part number so the quote covers the whole set.
Dimensions
- Section
- D
- Length
- 8280mm
Frequently asked questions
- What do the profile and length tell me about this belt?
- The D profile identifies the cross-section that must fit the pulley groove, and 8280 mm is the length. Both figures need to match the belt you are replacing.
- How do I confirm the P-D326 is the right belt?
- Check the marking on the back of the belt you are removing. If it shows P-D326, or the D profile with an 8280 mm length, that is the belt to quote.
- What should I send to request a quote?
- Send the part number P-D326, the quantity, and the drive details you have. If the old marking is unreadable, send the profile and measured length instead.