V-belt Movendis P-C72.75

MOVENDIS P-C72.75 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-C72.75 and any equivalents.

The Movendis P-C72.75 is a classical wrapped V-belt in the C profile, with a length of 1850 mm. It measures 22 mm across the top, 14 mm in height and is built with a 40 degree angle. This is the belt to specify when a drive calls for a wrapped classical section rather than a narrow wedge or cogged construction.

Classical wrapped V-belts of this type are common on older and slower industrial drives, on equipment where the pulley grooves are cut for a classical section, and on drives that see dusty or damp conditions where a wrapped cover is preferred. The C section suits medium-duty power transmission on fans, pumps, compressors, conveyors and similar machinery. If the drive was originally built around a classical C belt, fitting a narrow section in its place will not seat correctly in the groove.

To confirm fit, read the marking on the back of the old belt and compare it with the profile and length of the P-C72.75. Check the section against the pulley groove: a C belt is 22 mm at the top and 14 mm tall, and it should sit with the top edge roughly flush with the outside diameter of the sheave. Measure the outside length of the old belt against 1850 mm, and check that the angle matches the groove at 40 degrees.

When replacing belts on a multi-groove drive, inspect every belt in the set rather than only the failed one. Look for cracking, glazing, frayed covers, missing cord and uneven wear across the set, and check sheave grooves for wear, rust or embedded debris. Belts that have run together should be replaced together so the load stays evenly distributed.