V-belt Movendis P-C71.5

MOVENDIS P-C71.5 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-C71.5 and any equivalents.

The Movendis P-C71.5 is a classical wrapped V-belt in a C profile, with a 1816 mm length, 22 mm top width, 14 mm height and a 40° angle. When a drive comes in for service, the fastest way to confirm this is the right replacement is to match it to the belt being removed, marking for marking.

Start with the belt on the machine. Read the marking on the back of the old belt and compare it to the Movendis P-C71.5. The profile must be C, the length must be 1816 mm, and the cross-section must measure 22 mm across the top and 14 mm high. The 40° angle is the included angle of the belt cross-section and must match the sheave groove. If the old belt is worn, stretched or unreadable, measure the outside length and the top width with a caliper and compare those figures to the data here.

A classical wrapped V-belt like this one is a single belt, not a banded set. If the drive runs more than one belt, replace the full set at the same time so the belts share the load evenly. Inspect the sheaves for wear, rust or a polished groove floor before fitting the new belt, and check the alignment of the pulleys. A worn groove will let even a correctly sized belt sit too deep and slip.

If the part number on the old belt does not match, send us the marking, the profile letter and the measured length by WhatsApp or email. We carry Movendis belts and the team can confirm the right belt for the drive or suggest an equivalent. Include the machine or drive reference if you have it, and the quantity needed.