V-belt Movendis P-C248
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- C
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-C248 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-C248 and any equivalents.
The Movendis P-C248 is a classical wrapped V-belt in a C profile. It measures 6300 mm in length, 22 mm across the top, 14 mm in height and a 40-degree angle. To match it to the belt being replaced, read the marking on the old belt and confirm the profile and length before ordering.
Start by reading the marking on the back of the belt you are replacing. The part number, profile letter and length are normally printed there. If the marking is worn or missing, measure the outside length and the top width of the old belt. A C profile belt has a 22 mm top width and a 14 mm height, so those two dimensions will help confirm the profile. Compare what you find with the P-C248: C profile and 6300 mm length.
A belt that has run for a long time may measure slightly different from its original length. Use the printed marking as the primary reference and the measurements as a check. If the old belt is broken, lay it flat and measure its length along the back. If the drive uses more than one belt, replace the full set so the belts share the load evenly.
Send the part number you found, or the profile and length you measured, by WhatsApp or email. The team can confirm the right belt or suggest an equivalent.
Dimensions
- Section
- C
- Length
- 6300mm
Frequently asked questions
- How do I confirm the P-C248 is the right belt for my drive?
- Read the marking on the belt being replaced and compare the profile and length. The P-C248 is a C profile belt with a 6300 mm length, a 22 mm top width, a 14 mm height and a 40-degree angle. If the marking is not readable, measure the old belt and send those dimensions for confirmation.
- What should I send to request a quote for this belt?
- Send the part number P-C248, or the profile and length of the belt you need. If you are replacing an unmarked belt, include the top width, height and measured length. Photos of the belt and the drive can also help confirm the match.
- Should I replace all belts on a multi-belt drive at the same time?
- Yes. On a drive that uses more than one belt, replacing the full set helps keep the load shared evenly across the belts. Mixing a new belt with worn belts can cause the new belt to carry more than its share.