V-belt Movendis P-C178
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- C
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-C178 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-C178 and any equivalents.
The Movendis P-C178 is a classical wrapped V-belt with a C profile and a 4521 mm length. It is built for drives that use a 40-degree angle and a 22 mm top width by 14 mm height cross-section. Use this page to confirm the belt on your drive before you request a quote.
The most reliable way to match a replacement is to read the marking on the old belt. If the back of the belt shows P-C178, this is the same belt. If the marking is worn, measure the outside length and compare it to 4521 mm, then check the cross-section: 22 mm across the top and 14 mm high. A C profile belt should sit correctly in the pulley groove without riding on the bottom.
When you send your request, include the part number P-C178 and the drive it serves. If you are replacing more than one belt on the same drive, list every belt position and its marking. Our team can confirm the profile and length from your photos or measurements and help you avoid a mismatch on the first order.
Dimensions
- Section
- C
- Length
- 4521mm
Frequently asked questions
- How do I confirm that the P-C178 is the right belt for my drive?
- Check the marking on the back of the belt you are replacing. If it reads P-C178, the profile and length match. If the marking is not readable, measure the outside length and compare it to 4521 mm, and verify the cross-section is 22 mm top width by 14 mm height.
- What should I send with my quote request?
- Send the part number P-C178, the application or drive description, and a photo of the old belt marking if possible. If you are replacing a set, include the marking and position of each belt so we can confirm the correct profile and length.
- Can you help if the old belt marking is different?
- Yes. Send the marking you see, along with the measured length and cross-section. We will compare it to the P-C178 data: C profile, 4521 mm length, 22 mm top width, 14 mm height, and 40-degree angle. If it does not match, we can suggest an equivalent from the lines we carry.