V-belt Movendis P-C170
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- C
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-C170 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-C170 and any equivalents.
The Movendis P-C170 is a classical wrapped V-belt with a C profile and a length of 4318 mm. The profile and length are the two dimensions to match when selecting a replacement.
The C profile gives this belt a 22 mm top width, a 14 mm height and a 40-degree angle. Those dimensions, together with the 4318 mm length, define how the belt sits in the pulley groove and how it runs around the drive. Check the marking on the back of the old belt and compare it with these values before ordering.
The P-C170 is built for drives that take a classical wrapped V-belt in this profile and length. When you replace it, inspect the pulleys for wear and alignment at the same time. If a drive uses more than one belt, fit the full set together so the load stays even across the grooves.
To request a quote, send the part number P-C170 by WhatsApp or email. If you are unsure whether this is the correct belt, include the profile and length from the old belt or a photo of its back marking, and the team can help confirm the right belt or suggest an equivalent.
Dimensions
- Section
- C
- Length
- 4318mm
Frequently asked questions
- What do the profile and length tell me about this belt?
- The C profile sets the cross-section: 22 mm top width, 14 mm height and a 40-degree angle. The length is 4318 mm. Both must match the drive for the belt to seat and run correctly.
- How do I confirm the P-C170 is the belt I need?
- Read the marking on the back of the old belt and compare it with the profile and length above. If the marking is worn, send the part number or a photo by WhatsApp or email and the team can help confirm it.
- Should I replace all belts on a multi-belt drive at once?
- Yes. On a drive that uses several belts, fit the full set together so each belt carries its share of the load. Also check pulley wear and alignment while the drive is open.