V-belt Movendis P-B66.25
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- B
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-B66.25 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-B66.25 and any equivalents.
The Movendis P-B66.25 is a classical wrapped V-belt with a B profile and a length of 1680 mm. It has a top width of 17 mm, a height of 11 mm, and a 40-degree angle. To match it to the belt you are replacing, compare these dimensions directly with the old belt.
Start by checking the profile and length. The B profile is a common classical cross-section, and the 1680 mm length is the datum length. If the old belt is worn or the marking is unreadable, measure the top width and height to confirm the cross-section, then measure the outside length and compare it to the 1680 mm figure. A belt that is too long or too short will not tension correctly.
The 40-degree angle is the included angle of the V. This angle must match the pulley groove angle for proper wedging and power transmission. If the old belt has been running in worn pulleys, the angle may appear different, so inspect the pulleys as well. For a complete replacement, check all belts on the drive and replace them as a set if they have been running together.
When you request a quote, send the part number P-B66.25 and the dimensions you measured. If you are unsure, send a photo of the marking on the back of the old belt and the pulley groove width. Our team can confirm the right belt or suggest an equivalent based on the profile and length. We carry the Movendis P-B66.25 and can help you match it to your application.
Dimensions
- Section
- B
- Length
- 1680mm
Frequently asked questions
- How do I confirm the P-B66.25 is the right belt for my drive?
- Check the old belt for a B profile marking and a 1680 mm length. If the marking is gone, measure the top width (17 mm) and height (11 mm) to confirm the cross-section, and measure the outside length to compare with 1680 mm.
- What should I send to get a quote for this belt?
- Send the part number P-B66.25, the quantity you need, and any dimensions or photos of the old belt. If you have the pulley groove width, include that as well. Our team will confirm the belt or suggest an equivalent.
- Should I replace all belts on the drive at the same time?
- Yes, when multiple belts run on the same drive, they should be replaced as a set. Mixing new and worn belts can cause uneven tension and premature failure. Inspect the pulleys for wear and alignment before installing new belts.