V-belt Movendis P-B34
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- B
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-B34 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-B34 and any equivalents.
This Movendis P-B34 is a classical wrapped V-belt with a B profile and an 865 mm length. The 17 mm top width, 11 mm height and 40° angle identify the cross-section, while the length sets the fit on the drive. Use these four values to confirm the belt matches the pulley groove and the required span.
The B profile is a classical cross-section, not a narrow wedge or cogged design. The 40° angle is the included angle of the belt sides, which seats in a matching B-section pulley groove. The 865 mm length is the datum length for this belt, so compare it directly with the marking on the belt being replaced before ordering.
For a quote, send the part number P-B34 and the quantity. If the old belt is worn or the marking is unreadable, measure the top width and the length and note them with the request. The team can confirm the B profile and 865 mm length against the drive data you provide.
Inspect the pulleys for wear, alignment and debris before fitting a new classical V-belt. A groove that has worn wider will not support the 17 mm top width correctly, and the belt will sit too deep. Replace belts in sets where the drive uses more than one belt so the load stays shared.
Dimensions
- Section
- B
- Length
- 865mm
Frequently asked questions
- What do the profile and length tell me about this belt?
- The B profile gives the cross-section: 17 mm top width, 11 mm height and a 40° angle. The 865 mm length gives the datum length. Together they confirm the belt will match a B-section pulley groove and the required center distance.
- How do I confirm the P-B34 is the right replacement?
- Read the marking on the back of the old belt. If it shows a B profile and 865 mm, the P-B34 matches. If the marking is gone, measure the top width and the outside length and send those values with your quote request.
- What should I include when requesting a quote?
- Send the part number P-B34, the quantity, and any drive details you have, such as the pulley diameters or the application. If you are replacing a belt with an unreadable marking, include the measured top width and length.