V-belt Movendis P-B33
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- B
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-B33 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-B33 and any equivalents.
The Movendis P-B33 is a classical wrapped V-belt in the B profile, with an 840 mm length. This is the type of belt used on conventional industrial drives where a wrapped classical cross-section is called for. Confirm fit by comparing the profile, the length and the cross-section dimensions to the belt you are replacing.
The P-B33 carries the B profile: 17 mm across the top, 11 mm high, with a 40 degree angle. Its length is 840 mm. These are the figures to check against your drive before ordering, since a classical V-belt must seat correctly in the pulley groove and run at the right length for the center distance.
The most reliable way to confirm a replacement is to read the marking on the back of the old belt and measure it. If the belt is worn or the marking is gone, measure the top width and height of the cross-section and the length around the belt, then match those against the P-B33 figures. If the old belt is not a Movendis, that is not a problem; the profile and length are what determine whether it fits.
Send the part number or your measurements through WhatsApp or email and the team will confirm the P-B33 or suggest an equivalent. For drives running more than one belt, it is common practice to replace the full set at the same time so the belts share the load evenly.
Dimensions
- Section
- B
- Length
- 840mm
Frequently asked questions
- How do I confirm the Movendis P-B33 will fit my drive?
- Check three things against the old belt: the B profile, the 840 mm length, and the cross-section of 17 mm top width by 11 mm height at a 40 degree angle. If those match, the belt is the right size for the drive.
- What if I cannot read the marking on the old belt?
- Measure the top width and the height of the cross-section, and measure the length around the belt. Send those figures with a photo of the belt and the drive, and the team will match them to the P-B33 or suggest an equivalent.
- Should I replace all the belts on a multi-belt drive at once?
- Yes, on a drive running more than one belt it is standard practice to change the full set together. Belts of different wear or length do not share the load evenly, which shortens the life of the set.