V-belt Movendis P-B25
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- B
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-B25 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-B25 and any equivalents.
The Movendis P-B25 is a classical wrapped V-belt in a B profile. Before you order, match it to the belt you are replacing by checking the marking on the old belt and confirming the profile and length.
The P-B25 measures 635 mm in length, 17 mm across the top, 11 mm in height, and has a 40-degree angle. These are the dimensions to compare against the belt on the drive. A B profile belt that is too long or too short will not tension correctly, and a different top width will not sit properly in the pulley groove.
The most reliable way to identify a replacement is to read the marking on the back of the old belt. The profile letter and length are usually printed there. If the marking is worn or missing, measure the outside length and the top width with the belt laid flat, then compare those numbers to the P-B25 dimensions above.
If the old belt is cracked, glazed, or has exposed cords, replace it before it fails. On drives with multiple belts, replace the full set at the same time so the load stays evenly distributed. Send the part number, the profile, and the length from your old belt when you request a quote, and we will confirm whether the P-B25 is the right match.
Dimensions
- Section
- B
- Length
- 635mm
Frequently asked questions
- How do I match the P-B25 to the belt I am replacing?
- Check the marking on the back of the old belt for the profile and length. The P-B25 is a B profile belt, 635 mm long, 17 mm across the top, 11 mm high, with a 40-degree angle. If the old marking is unreadable, measure those dimensions on the old belt and compare.
- What should I send to get a quote for this belt?
- Send the part number P-B25, or the profile and length from the belt you are replacing. If you have the old belt in hand, the marking on the back is the fastest way to confirm the match. We will reply by WhatsApp or email.
- Should I replace all the belts on the drive at once?
- On a multi-belt drive, replacing the full set keeps tension and load sharing even. Mixing a new belt with worn belts can cause the new belt to carry more than its share. Use the P-B25 for each position if it matches the original profile and length.