V-belt Movendis P-A80
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-A80 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-A80 and any equivalents.
The Movendis P-A80 is a classical V-belt in the A profile, with a 2035 mm length, 13 mm top width and 8 mm height. It is built to the 40° angle that defines the A cross-section. When you are replacing a belt, the marking on the old belt is the fastest way to confirm this is the right one.
To match the P-A80 to the belt being replaced, read the marking on the back of the old belt. Look for the A profile and the 2035 mm length, then compare the top width and height: 13 mm and 8 mm. If the old belt is worn or the marking is gone, measure the top width and the outside length so you can check them against these figures.
The 40° angle and the A profile determine how the belt sits in the pulley groove. A belt that is too wide will not seat correctly; one that is too narrow will ride low. Use the P-A80 when the drive calls for an A-section classical V-belt at 2035 mm.
For a quote, send the part number P-A80 and the quantity you need. If the old belt carries a different number, send that marking and the measured profile and length, and the team can confirm whether the P-A80 is the correct replacement.
Dimensions
- Section
- A
- Length
- 2035mm
Frequently asked questions
- How do I confirm the P-A80 matches the belt I am replacing?
- Check the marking on the back of the old belt for the A profile and the 2035 mm length, and compare the top width and height. The P-A80 has a 13 mm top width and 8 mm height at a 40° angle.
- What measurements should I send if the old belt marking is unreadable?
- Send the top width, the height and the outside length you measure, along with the pulley groove width if you have it. The team can compare those figures with the P-A80's 13 mm top width, 8 mm height and 2035 mm length.
- How do I request a quote for the P-A80?
- Send the part number P-A80 and the quantity you need by WhatsApp or email. If you are not sure of the number, include the old belt's marking and your measurements so the team can confirm the correct belt.