V-belt Movendis P-A77.5
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-A77.5 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-A77.5 and any equivalents.
The Movendis P-A77.5 is a classical wrapped V-belt in the A profile, 1970 mm long. It measures 13 mm across the top and 8 mm high, with a 40-degree angle. This page covers how to match it to the belt you are replacing.
Start with the belt on the drive. Read the marking on the back: the part number, the profile letter and the length. The P-A77.5 carries an A profile and a 1970 mm length, so a replacement needs the same profile and the same length. Check the top width and height against the old belt as well; the figures here are 13 mm and 8 mm.
Inspect the drive before ordering. Look for worn sheave grooves, misalignment, oil or heat exposure, and any idler or tensioner that no longer moves freely. A belt that failed early often points to a drive problem rather than a belt problem. If the drive runs more than one belt, replace the full set so the belts share the load evenly.
When you request a quote, send the part number P-A77.5, the profile and length from the old belt marking, and the quantity you need. If the marking is worn or unreadable, send the drive details and a photo of the belt and sheaves. The team can confirm the right belt or suggest an equivalent.
Dimensions
- Section
- A
- Length
- 1970mm
Frequently asked questions
- How do I confirm the P-A77.5 matches the belt I am replacing?
- Compare the marking on the old belt with the P-A77.5: A profile, 1970 mm length, 13 mm top width, 8 mm height and a 40-degree angle. If the old marking is unreadable, measure the belt and the drive and send those details for confirmation.
- Can I replace just one belt on a multi-belt drive?
- Where a drive uses more than one belt, replacing the full set keeps tension and load sharing even. A single new belt alongside worn belts can carry more than its share.
- What should I send to get a quote?
- Send the part number P-A77.5, the quantity, and the profile and length from the old belt marking. If the marking is gone, send the drive details and a photo of the belt and sheaves.