V-belt Movendis P-A44
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-A44 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-A44 and any equivalents.
The Movendis P-A44 is a classical wrapped V-belt in the A profile with a length of 1120 mm. It is used on conventional industrial drives where a wrapped classical belt is the specified replacement. Confirm the belt on the drive matches the profile and dimensions before ordering.
Classical wrapped V-belts like this one are common on fans, pumps, compressors, mixers and other general industrial drives. The wrapped construction suits drives where the belt runs over standard V-grooved pulleys. The P-A44 carries an A profile, a top width of 13 mm, a height of 8 mm and a 40 degree angle.
To confirm fit, read the marking on the back of the old belt and compare it with the P-A44. Check the profile against the pulley groove, then verify the top width, height and 1120 mm length. If the drive uses multiple belts, replace the full set at the same time so the belts share the load evenly.
If the marking is worn or missing, measure the old belt and send the profile, top width, height and length with your quote request. Our team can confirm the P-A44 or suggest an equivalent.
Dimensions
- Section
- A
- Length
- 1120mm
Frequently asked questions
- What does the P-A44 fit?
- The P-A44 is a classical wrapped V-belt in the A profile with a length of 1120 mm. It fits drives that specify an A profile belt of this length, top width and height.
- How do I confirm the right belt for my drive?
- Compare the profile, top width, height and length against the old belt or the drive specification. If the marking is unreadable, measure the old belt and send those dimensions for confirmation.
- Should I replace all belts on a multi-belt drive?
- Yes. On a drive with more than one belt, replace the full set so the belts are matched and carry the load evenly.