V-belt Movendis P-A30
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-A30 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-A30 and any equivalents.
The Movendis P-A30 is a classical wrapped V-belt with an A profile and a 762 mm length. It is built to the standard A cross-section: 13 mm top width, 8 mm height and a 40-degree angle. Matching it to the belt being replaced starts with those three dimensions.
To confirm the P-A30 is the right replacement, read the marking on the back of the old belt. Look for the profile letter and the length, then compare them with the A profile and 762 mm length of this belt. The top width of 13 mm, height of 8 mm and 40-degree angle should also match the old belt and the pulley groove it runs in.
If the old belt is worn or the marking is unreadable, measure across the top of the belt for width and around the outside for length. A belt that has stretched or worn narrow can measure under the original figures, so check the pulley groove for wear as well. When the profile and length line up, the P-A30 is the correct match.
For a quote, send the part number P-A30, the quantity you need and the equipment it goes on. If you are unsure between this belt and another, include the old belt's marking or its measured profile and length. We carry the Movendis line and can help confirm the right belt or suggest an equivalent.
Dimensions
- Section
- A
- Length
- 762mm
Frequently asked questions
- How do I match the Movendis P-A30 to the belt I am replacing?
- Compare the profile letter and length on the old belt's back marking with the A profile and 762 mm length of the P-A30. Also check the cross-section: 13 mm top width, 8 mm height and a 40-degree angle. If those match, it is the correct belt.
- What measurements should I send if the old belt marking is gone?
- Measure the top width and the outside length of the old belt, and note the pulley groove width if you can. Send those figures along with the part number P-A30 and the equipment details. We will help confirm the match.
- Can you help if I am not sure the P-A30 is the right belt?
- Yes. Send the part number P-A30, the old belt's marking or its measured profile and length, and the quantity you need. We will review the details and help confirm the right belt or suggest an equivalent.