V-belt Movendis P-A196
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Classical Wrapped V-Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-A196 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-A196 and any equivalents.
This Movendis P-A196 is a classical wrapped V-belt with an A profile and a length of 4980 mm. It is used on industrial drives where a single, long belt runs between two pulleys, such as line shafting, large fans, or slow-speed transmission equipment. Confirm fit by checking the profile and length against your drive before ordering.
The P-A196 has a top width of 13 mm, a height of 8 mm, and a 40° angle. These dimensions match the A profile, so the belt sits correctly in an A-section pulley groove. The 4980 mm length is the datum length for this belt, and it must match the drive's required belt length for proper tension and alignment.
To confirm fit, read the marking on the back of your old belt. If it shows an A profile and a 4980 mm length, the P-A196 is the correct size. Also inspect the pulleys for wear, cracks, or debris, and check that the grooves are clean and free of rust. A worn pulley can cause a new belt to seat incorrectly and wear quickly.
When ordering, send the part number P-A196, the profile A, and the length 4980 mm. If you are replacing multiple belts on the same drive, replace them as a set to keep tension even. For a quote, contact MR via WhatsApp or email with the belt marking or the dimensions from your drive.
Dimensions
- Section
- A
- Length
- 4980mm
Frequently asked questions
- What does the A profile mean for this belt?
- The A profile indicates a classical V-belt with a 13 mm top width, 8 mm height, and 40° angle. It fits pulleys with a corresponding A-section groove.
- How do I confirm the P-A196 will fit my drive?
- Check the marking on your old belt for an A profile and a 4980 mm length. Also measure the pulley groove width and inspect for wear.
- Can I use this belt on a drive that takes multiple belts?
- Yes, but replace all belts on the drive at the same time. Mixing new and old belts can cause uneven tension and premature wear.