Timing belt Movendis P-495-3M-480
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Curvilinear H-Type Timing Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-495-3M-480 belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-495-3M-480 and any equivalents.
This Movendis P-495-3M-480 is a curvilinear H-type timing belt with an HTD 3M profile and a 495 mm length. It is used in compact, low-power drives where exact tooth engagement and positioning matter, such as small conveyors, instrumentation, and light-duty motion systems. Confirm fit by matching the profile, length, and pitch to your drive before ordering.
Because timing belts must match the pulley groove and center distance, the safest way to select a replacement is to read the marking on the back of the old belt and compare it with the profile and length on this page. The HTD 3M profile and 495 mm length identify the tooth form and the belt's length; the 3 mm pitch is the distance between tooth centers. If the old marking is worn or missing, measure the belt width and count teeth only as a cross-check, and confirm the pulley profile is HTD 3M.
This belt is a curvilinear H-type timing belt, a construction used for synchronous drives that need consistent timing rather than friction. Inspect the drive for worn pulley teeth, misalignment, and correct tension before installing a new belt. If the drive runs more than one belt, replace the set together so the load is shared evenly.
Dimensions
- Profile
- HTD 3M
- Pitch
- 3mm
- Length
- 495mm
Frequently asked questions
- How do I confirm this Movendis P-495-3M-480 fits my drive?
- Match the belt marking to the HTD 3M profile and 495 mm length, and confirm the pulleys are HTD 3M with a 3 mm pitch. If the marking is unreadable, check the pulley profile and center distance.
- What should I send to request a quote?
- Send the part number P-495-3M-480, the quantity, and the belt width. If you are replacing an unmarked belt, include the profile and length from the old belt or drive documentation.
- Can I replace just one belt in a multi-belt drive?
- For drives that use more than one belt, replace the set at the same time so all belts carry the load evenly. Check pulley wear and alignment before installing the new belts.