Timing belt Movendis P-345-3M-480
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Curvilinear H-Type Timing Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-345-3M-480 belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-345-3M-480 and any equivalents.
The Movendis P-345-3M-480 is a timing belt in the Curvilinear H-Type series with an HTD 3M profile and a 345 mm length. It uses a 3 mm pitch. To confirm it matches the belt being replaced, compare these markings and dimensions with the belt on the drive.
Start with the marking on the back of the old belt. The part number P-345-3M-480 identifies the profile and length, so it should correspond to the HTD 3M profile and 345 mm length shown here. If the old belt is worn or the print is gone, measure the length and check the tooth profile against the pulley.
The HTD 3M profile and 3 mm pitch must match the pulleys. A belt with the same length but a different profile will not seat correctly. Confirm the belt sits fully in the pulley grooves and that the teeth mesh without binding before ordering.
If you are unsure, send the part number from the old belt, the profile, and the length in your quote request. We carry the Movendis P-345-3M-480 and can help confirm it is the correct belt for your drive.
Dimensions
- Profile
- HTD 3M
- Pitch
- 3mm
- Length
- 345mm
Frequently asked questions
- How do I confirm the Movendis P-345-3M-480 fits my drive?
- Check the marking on the back of the belt you are replacing. It should show the same part number or the HTD 3M profile and 345 mm length. Also verify the 3 mm pitch matches your pulleys.
- What should I send to request a quote?
- Send the part number P-345-3M-480, or the profile and length from the old belt, by WhatsApp or email. If you have a photo of the belt marking, include it to help us confirm the match.
- Can I use this belt if the old belt has no readable marking?
- Yes. Measure the length and identify the tooth profile. The replacement must have an HTD 3M profile, a 345 mm length, and a 3 mm pitch to match the pulleys.