Timing belt Movendis P-200-H-480
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Classical Imperial Timing Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-200-H-480 belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-200-H-480 and any equivalents.
The Movendis P-200-H-480 is a timing belt in the Classical Imperial Timing Belts series. It has an H profile and a length of 508 mm. Before you fit it, inspect the drive and sheaves so the new belt runs true.
Check the sheaves for worn grooves, burrs, or debris that can damage the belt teeth. Confirm the shafts turn freely and the bearings have no play. Misalignment or a bad bearing will shorten the life of any timing belt, including this H-profile belt.
Verify the old belt marking against the part number P-200-H-480. The profile is H and the length is 508 mm. If the drive uses more than one belt, replace the full set so the load stays even across all belts.
When you request a quote, send the part number P-200-H-480 and the quantity you need. If the marking on the old belt is hard to read, send a photo of the back of the belt and the drive arrangement. The team can confirm the H profile and 508 mm length against your application.
Dimensions
- Profile
- H
- Length
- 508mm
Frequently asked questions
- What should I check on the drive before installing the P-200-H-480?
- Inspect the sheaves for wear, burrs, or debris, and check that the shafts spin freely and the bearings are tight. Correct any misalignment before fitting the new belt.
- How do I confirm this is the right belt for my drive?
- Compare the marking on the old belt to the part number P-200-H-480. This belt has an H profile and a length of 508 mm. If the marking is unclear, send a photo of the back of the belt.
- Can I replace just one belt on a multi-belt drive?
- It is best to replace all belts in the drive at the same time. A new belt mixed with used belts can run at a different tension and may not carry its share of the load.