Timing belt Movendis P-1595-D/5M-180
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Curvilinear Double-Sided Timing Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-1595-D/5M-180 belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-1595-D/5M-180 and any equivalents.
The Movendis P-1595-D/5M-180 is a curvilinear double-sided timing belt from the Curvilinear Double-Sided Timing Belts series. Its 1595 mm length and 5M curvilinear profile are the two figures to match against your drive before ordering.
The 5M profile places this belt in the 5 mm curvilinear pitch family, and the 1595 mm figure is the belt length. Both matter on a double-sided drive: the belt runs on both faces, so the tooth geometry has to suit the pulleys at each end of the run, and the length has to suit the fixed center distance. Confirm both against the drive you are replacing rather than against a general size.
A double-sided timing belt is used where the drive needs synchronized motion from both faces of the belt. If the belt you are removing carries the same marking, that is the simplest confirmation. If the marking is worn or unreadable, measure the length and count the profile from the pulleys, then send those details with the part number.
Send the part number P-1595-D/5M-180 by WhatsApp or email and we will confirm the belt or suggest an equivalent. Including the drive details and a photo of the old belt marking helps us get it right the first time.
Dimensions
- Length
- 1595mm
Frequently asked questions
- What does the 5M profile mean on this belt?
- It identifies the belt as part of the 5 mm curvilinear pitch family. The pulley grooves on your drive must match that profile, and because this is a double-sided belt, both faces engage pulleys.
- How do I confirm the 1595 mm length is correct?
- Check the marking on the back of the belt you are removing, or measure the belt and compare it to the 1595 mm figure. The length has to suit the fixed center distance of the drive.
- What should I send with the part number for a quote?
- Send the part number P-1595-D/5M-180, the drive or equipment details, and a photo of the old belt marking if it is readable. We will confirm the belt or suggest an equivalent.