Timing belt Movendis P-1300-5M-480

MOVENDIS P-1300-5M-480 belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-1300-5M-480 and any equivalents.

The Movendis P-1300-5M-480 is a timing belt in the Curvilinear H-Type series with an HTD 5M profile, a 1300 mm length and a 5 mm pitch. This page covers how to match it to the belt you are replacing. Send the part number to our team for a quote.

Start with the marking on the back of the old belt. Read the profile and the length together, because a belt that looks right on the drive can still be the wrong size. The replacement must carry the HTD 5M profile and the 1300 mm length, with the 5 mm pitch that defines the tooth spacing. If the old marking is worn or unreadable, measure the belt and count the teeth rather than guessing from the drive alone.

Once the profile and length are confirmed, check the drive before the new belt goes on. Look at the pulleys for worn teeth, the flanges for damage, and the tensioner for smooth travel. A belt that fails early often points to a worn pulley or a misaligned drive rather than the belt itself. Replacing the belt without addressing those points usually leads to the same failure again.

If the belt runs in a set with others on the same drive, replace them together so the drive stays balanced. Keep the old belt until the new one is fitted and the drive has been checked. The part number P-1300-5M-480 is what we need to quote.