Timing belt Movendis P-1135-5M-450
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Curvilinear H-Type Timing Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-1135-5M-450 belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-1135-5M-450 and any equivalents.
The Movendis P-1135-5M-450 is a curvilinear H-type timing belt with an HTD 5M profile and a 1135 mm length. Its 5 mm pitch identifies the tooth spacing used to match the belt to the pulley groove. Use these three values to confirm the belt against your drive before you order.
The profile and length are the two fields that decide fit. HTD 5M describes the curvilinear tooth form and the 5 mm pitch, so the belt seats correctly in a matching 5M pulley. The 1135 mm length is the belt's own dimension and must agree with the drive's required length, not with a nearby size that looks close.
When you request a quote, send the part number P-1135-5M-450 together with the profile and length from the old belt's back marking. If the marking is worn, a photo of the belt and the drive helps us confirm the HTD 5M profile and the 1135 mm length and suggest an equivalent.
For drives that run more than one belt, replace the set together so the load stays even across the pulleys. Inspect the pulleys for worn grooves, and check the belt for cracked teeth or exposed cord before you install a replacement.
Dimensions
- Profile
- HTD 5M
- Pitch
- 5mm
- Length
- 1135mm
Frequently asked questions
- What do the profile and length tell me about this belt?
- The HTD 5M profile gives the curvilinear tooth form and the 5 mm pitch, which must match the pulley groove. The 1135 mm length is the belt's dimension and must match the drive's required length.
- How do I confirm the right belt for my drive?
- Read the marking on the back of the old belt and compare the profile and length with the P-1135-5M-450. If the marking is unclear, send a photo of the belt and the drive with your quote request.
- Can I replace just one belt in a multi-belt drive?
- Replace the full set at the same time so the belts share the load evenly. Also inspect the pulley grooves and check the old belts for cracked teeth or exposed cord.