V-belt Movendis HP+ 3281008-28
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- V-belts
- Series
- HP+
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS HP+ 3281008-28 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for HP+ 3281008-28 and any equivalents.
The Movendis HP+ 3281008-28 is a CVT belt for motorcycles and scooters, sized at 1008 mm outside length, 28 mm width, and a 28° angle. It is listed for the Suzuki AN 400 Burgman from 2007 to 2020. Before fitting a new belt, inspect the drive and sheaves so the new belt runs on clean, true surfaces.
CVT wear is not limited to the belt. Check the sheave faces for grooves, scoring, or a step where the belt has been running. Worn sheaves can quickly damage a new belt, so measure the sheave surfaces and replace any part that is out of specification. Confirm that the variator and clutch move freely through their full travel.
The Movendis HP+ 3281008-28 is also listed under the cross-references Mitsuboshi MBLSC054 and OE 27601-05H10. Use these to match the belt you are removing, and check the old belt for its marking before ordering. If you need help confirming the right belt or an equivalent, send the part number by WhatsApp or email.
Install the new belt only after the sheaves and drive are clean and in good condition. Work the belt into the variator and clutch without forcing it, then rotate the drive to seat it. After a short run-in period, recheck belt tension and sheave condition to catch any early wear.
Dimensions
- Length
- 1008mm
Frequently asked questions
- What does the Movendis HP+ 3281008-28 fit?
- It is listed for the Suzuki AN 400 Burgman from 2007 to 2020.
- What are the dimensions of this belt?
- 1008 mm outside length, 28 mm width, and a 28° angle.
- What should I check before fitting this belt?
- Inspect the sheave faces for wear or grooves, confirm the variator and clutch move freely, and clean the drive. Replace any worn sheave components.