V-belt Mitsuboshi SPZX 800

MITSUBOSHI SPZX 800 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPZX 800 and any equivalents.

The Mitsuboshi SPZX 800 is a cogged narrow V-belt with an SPZX profile and a length of 800 mm. The profile and length are the two values you need to match or replace a belt on a known drive. Use them to confirm the belt will sit correctly in the pulley groove and span the drive centers.

When you read a belt marking, the profile tells you the cross-section family and the length gives you the datum length in millimeters. SPZX is a narrow wedge profile with a cogged construction, which is common where space is tight and the drive runs over smaller pulleys. The 800 mm length is the figure to compare against the old belt or the drive specification. If both the profile and the length match, the belt is the correct size for that position.

Replacement is straightforward when the marking on the back of the belt is still legible. Note the full code, including the profile and the length, before the old belt is removed. If the marking has worn away, measure the outside length and the top width, and check the pulley groove dimensions. Send those details along with the part number, and the team can confirm the right belt or suggest an equivalent.

Cogged narrow V-belts are often used in sets on multi-groove drives. If the drive uses more than one belt, replace all belts in the set at the same time so the load stays even across the grooves. Inspect the pulleys for wear, alignment and debris while the belts are off. A worn pulley groove can shorten the life of a new belt, even when the profile and length are correct.