V-belt Mitsuboshi C 170
- Brand
- MITSUBOSHI
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- C
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
GATES and MITSUBOSHI: matching part numbers →MITSUBOSHI and OPTIBELT: matching part numbers →
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MITSUBOSHI C 170 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for C 170 and any equivalents.
The Mitsuboshi C 170 is a classical V-belt with a C profile. Before you fit a new belt, inspect the drive and sheaves so the replacement runs correctly from the start.
Check sheave grooves for wear, rust, or embedded debris. Worn grooves let the belt sit too deep and slip, which shortens belt life. Confirm the sheaves are aligned and the driven equipment turns freely by hand. The C 170 has a 22 mm top width, 14 mm height, and 40° angle, so the grooves must match that profile.
When you replace the belt, examine the entire drive. Look for oil or heat sources, loose mounts, and worn bearings. If the drive uses multiple belts, replace them as a set so the load stays even. The same size is also listed under Optibelt C 170.
For a quote, send the part number C 170 by WhatsApp or email. The team can confirm the belt or suggest an equivalent. If the old belt is hard to read, send a photo of the marking on the back and the sheave dimensions.
Dimensions
- Section
- C
Frequently asked questions
- What should I check on the drive before installing a Mitsuboshi C 170?
- Inspect sheave grooves for wear, rust, or debris, and verify alignment. Confirm the sheaves match the C profile with its 22 mm top width, 14 mm height, and 40° angle. Also check that the driven equipment turns freely.
- Can I replace just one belt in a multi-belt drive?
- If the drive uses multiple belts, replace them as a set. Mixing a new belt with worn belts can cause uneven load and premature failure.
- How do I request a quote for the C 170?
- Send the part number C 170 by WhatsApp or email. The team can confirm the belt or suggest an equivalent. If the marking is worn, include a photo of the back of the belt and the sheave dimensions.