LINK-BELT YG2E32NL insert bearing

LINK-BELT YG2E32NL belongs to insert bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for YG2E32NL and any equivalents.

For equipment that relies on a rotating shaft supported with some flexibility, the LINK-BELT 200 series insert bearing is a common choice. This ball bearing comes with an extended inner ring and is intended for mounting in split plummer block housings and wall units. Typical applications include conveyors, mixers, and fans. MR Industrial Accessories supplies this line and can help you select the right variant for your specific setup.

The 200 series part number follows a logical structure. The letters YG denote the LINK-BELT insert family. The number that follows—20 or 32—refers to the shaft diameter in inches or millimeters, depending on the catalog. Suffixes such as E, NL, and final symbols indicate design details like locking method, sealing, or tolerance. Because of this, two similar-looking codes, such as YG2E20NL*Δ■ and YG2E32NL*Δ■, may have different dimensions and uses. Always provide the complete code when requesting a quote.

These inserts are widely used in conveyors at grain, food, and cement plants, as well as in mixers, screens, and other process equipment. They also appear in road and agricultural machinery exposed to dust and vibration. The 200 series is the most common for shafts up to about 2 inches. Mounting in split plummer block housings simplifies maintenance because the shaft does not need to be fully disassembled.

When selecting, consider the shaft diameter, locking type—set screw, eccentric, or adapter—and the sealing needed for the environment: dust, water, or frequent washdowns. Factory lubrication typically lasts for several seasons, but in demanding applications, schedule relubrication. Before tightening, check housing alignment and axial play. Avoid striking the insert during mounting to prevent damage to the raceways.

LINK-BELT 200 series inserts are interchangeable with other brands that use the same dimensional nomenclature, such as SKF, FAG, NTN, or NSK, provided the shaft diameter, inner ring width, and locking type match. A similar code alone is not sufficient; dimensions and sealing configuration must be compared. If you are unsure, send us a photo or the old bearing code, and we will identify a compatible alternative.

MR Industrial Accessories supplies the LINK-BELT line and can quote the insert you need. Contact us on WhatsApp with the code YG2E20NL*Δ■, YG2E32NL*Δ■, or the one on your equipment. We will reply promptly with the variant suitable for your application.