LINK-BELT YG226NL insert bearing

LINK-BELT YG226NL belongs to insert bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for YG226NL and any equivalents.

The LINK-BELT YG series is a ball bearing insert built with an extended inner ring, intended for installation in split plummer block housings, pillow block units and flanged units. The shaft locks onto the inner ring, while the insert itself accommodates the small misalignments that show up during assembly of power transmission equipment. MR Industrial Accessories supplies this line and helps you match the right variant to your shaft and housing.

Read the YG code in sections. The letters YG mark the insert family with extended inner ring. The digits that follow give the size inside that series. A suffix such as NL describes how the insert locks and seals. In YG210NL, YG211NL and YG212NL, only the size changes. YG214NL, YG215NL and YG216NL belong to the same family as further variants. The YG300 series follows the same pattern with its own sizes. Send the full code by WhatsApp or email and the team will quote that exact reference.

Typical applications include belt conveyors, bucket elevators, mixers, mills, packaging lines and process equipment in food, chemical and aggregate plants. These inserts also appear in agricultural machinery and material handling equipment that runs long shafts with separate housings. In plants where dust, moisture or frequent washdowns are present, the sealing of the insert is what sets how long it lasts in service.

Selection comes down to three things: shaft diameter and tolerance, the locking method on the inner ring, and the seal type. Fine dust or water calls for a tighter seal. Before tightening, confirm that the housings are aligned. Lubricate according to the duty cycle and keep impacts away from the ring while mounting. If the equipment starts to vibrate or run hot, inspect the clearance and the housing condition before swapping out the insert.

Interchange between inserts from different manufacturers depends on outer ring dimensions, width and locking system, not on the series number alone. Compare against the drawing you have, or send the housing measurements. MR Industrial Accessories can point you to a compatible alternative when the original reference is not what you need, and also manufactures split plummer block housings, roller chains and sheaves to complete the assembly.