LINK-BELT UG2M100NL insert bearing

LINK-BELT UG2M100NL belongs to insert bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for UG2M100NL and any equivalents.

The UG200 from LINK-BELT is a single-row ball insert bearing built with an extended inner ring, so it fits into split and pillow block housings and carries moderate radial and axial loads on rotating shafts. Conveyors, agitators, pumps, fans and process equipment are typical homes for this insert, where mounting is simple and the seal keeps contaminants out.

Reading the code is straightforward. The letters UG mark the family: insert bearing, extended inner ring, set screw locking. The 200 block refers to the metric diameter series. After the M comes the shaft size, which is why UG2M17NL, UG2M20NL, UG2M25NL, UG2M30NL, UG2M35NL, UG2M40NL, UG2M45NL and UG2M50NL span shafts of 17 mm through 50 mm. The NL suffix describes the seal, and other symbols in the number point to locking variants or design details. Give us the full number and we can quote that exact reference.

You will find these inserts in food and beverage plants, material handling, water treatment, cement and chemical operations. They run in belt and chain conveyors, bucket elevators, mixers, dryers, centrifugal pumps and industrial fans. Because the inner ring extends beyond the bearing, the insert seats in a split housing, which makes changeouts easier where space is tight and the shaft can go back into service without tearing down the whole assembly.

Selection starts with three items: shaft diameter, load type and the environment around the bearing. The NL seal is there to keep dust and moisture away from the rolling elements; where washdowns are frequent or particles are fine, watch the seal lips and the lubricant condition. Slide the insert onto a clean shaft free of burrs, then tighten the set screws on the inner ring with the correct wrench. Housings that are aligned with each other avoid extra load and help the bearing reach its expected life. Use the lubricant the equipment builder specifies and refresh it on the maintenance schedule.

Metric inserts such as the UG200 can be swapped between brands when shaft size, width and locking method line up. When you compare numbers, check the shaft diameter, the seal type and how the insert locks, since a different outer ring or a shifted set screw position can stop it from mounting. Replacing an existing insert? Send the number stamped on the bearing, or the shaft and housing dimensions, and we will point you to a compatible option.

MR Industrial Accessories LLC supplies the LINK-BELT line and serves customers throughout the United States and in several Latin American countries. For a UG200 insert, message us on WhatsApp or by email with the part number or model: we reply promptly, quote it and help you confirm the right choice. We can also advise on housings, seals and lubricants that go with your application.