LINK-BELT PL3U2M17N pillow block bearing

LINK-BELT PL3U2M17N belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PL3U2M17N and any equivalents.

Mounted bearings in the LINK-BELT 200 Series carry rotating shafts on industrial machinery, combining a self-aligning insert with a housing that bolts down to a flat surface. They suit equipment where a low-profile foot mount and straightforward shaft support are preferred over a custom bearing arrangement. MR Industrial Accessories LLC supplies this line and helps buyers match the correct unit to their shaft and load conditions.

The part number tells you what you are holding. Letters at the start point to the series and housing style, while the trailing digits tie back to shaft size. Units PL3U2M17N, PL3U2M20N and PL3U2M25N follow that same pattern, differing only in the closing figure. Treat that figure as the reference to pass along when requesting a quote, since it is what lets our team pull the matching unit or a suitable equivalent.

Typical duty covers conveyors, belt drives, elevators, mixers, pumps and fans. Plants handling food, chemicals, cement and aggregates favor these housings because they tolerate minor shaft misalignment and combined loading. Material handling systems and process lines also use them, particularly where bolting to steel framework or a concrete pad keeps installation simple.

Selection comes down to three things: shaft diameter, the nature of the load (radial, axial or a mix of both), and where the unit will operate. Dusty, wet or washdown-heavy areas call for a version with heavier sealing. The base must sit flat, the fit must be firm, and the shaft must line up properly; misalignment is a common cause of shortened bearing service. Follow the lubricant specified for the unit and refresh it on a schedule that matches the duty cycle. Because the housing is separate, a bearing can be swapped out without tearing down the whole machine.

Interchange with other manufacturers is possible when the mounting nomenclature lines up, provided shaft diameter, locking method and base dimensions all agree. A similar-looking part number is not enough on its own. Center height, hole spacing and the locking system have to be checked before anything is ordered. Send the original reference and we will point you to a compatible option.

To move forward, message us on WhatsApp or by email with the part number or the model printed on the nameplate. Our team replies promptly, quotes the reference you need and can also advise on seals, lubrication and mounting so the unit performs as intended.