LINK-BELT PKEB22571YFH flange bearing 4 holes

LINK-BELT PKEB22571YFH belongs to flange bearing 4 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PKEB22571YFH and any equivalents.

A 4-hole flange bracket from the Link-Belt B22500 series is a mounted bearing that bolts flat to a wall, frame or structure, with the shaft passing through the bore. Because the flange carries the load, it suits positions where a pillow block will not fit and where the bearing has to take radial load plus a measure of axial thrust. MR Industrial Accessories LLC supplies this line to plants and workshops throughout the United States and in several Latin American countries.

Reading the code helps you order the right unit. The prefix PKEB marks the 4-hole flange family, the block B22500 identifies the size and mounted bearing series, and the YFH suffix describes how the assembly is sealed and fastened. Two references such as PKEB22567YFH and PKEB22580YFH belong to the same series but differ in size, so the suffix alone does not tell you which bore you need. Copy the part number exactly as it appears on the nameplate or drawing when you send it.

These brackets turn up on belt and chain conveyors, bucket elevators, mixers, mills, centrifugal pumps and other process equipment. Food plants, cement operations, tanneries, water treatment works and packaging lines use them where bolting to a wall or frame frees up floor space and makes alignment easier. You will also find them on agricultural machinery and on handling equipment working in dust, moisture or washdown conditions.

Selection comes down to shaft diameter, the way the shaft is locked to the bearing, and the sealing the surroundings demand. The YFH suffix sets a seal and collar arrangement that should be maintained when dirt or liquid is present. On installation, seat the flange against a flat, rigid surface, draw the four bolts down in a cross pattern, and confirm the shaft lines up with the driven equipment. Follow the duty cycle for relubrication and check axial play before the machine runs.

Square and round flange mounted bearings from other lines can stand in for the B22500 series, but bore size is only one of the dimensions that must match. Hole spacing, flange outside diameter, center height and fastening method all change between lines, so the replacement has to reproduce those figures. MR will point you to the unit that fits the dimensions of your equipment.

When a 4-hole flange bracket needs replacing, send the full part number, a photo of the part, and the shaft and flange dimensions by WhatsApp or email. With that information the team can quote the Link-Belt unit or the closest alternative and advise on mounting and lubrication.