LINK-BELT PKEB224M80FH pillow block bearing

LINK-BELT PKEB224M80FH belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PKEB224M80FH and any equivalents.

The Link-Belt PKEB is a two-bolt pillow block housing built around a B22400 series insert bearing. It carries rotating shafts where the load is mostly radial and the mounting surface is flat, and because the insert comes out on its own, the housing can stay in place when the bearing is replaced. MR Industrial Accessories LLC supplies this line in the United States and Latin America.

Reading the code tells you what you are ordering. PKEB covers the housing style and the way the insert locks to the shaft; the digits after it give the housing size. Codes in this family run PKEB224M45FH, PKEB224M50FH, PKEB224M55FH, PKEB224M60FH, PKEB224M65FH, PKEB224M70FH, PKEB224M75FH and PKEB224M80FH. The FH ending describes the seal arrangement, and the letters in the middle point to the locking variant of the insert. Sizing on the size number alone is not enough; the whole string has to match.

Typical service includes belt conveyors, bucket elevators, mills, mixers, centrifugal pumps and other process equipment in food, chemical, cement and aggregate plants. The flat base with two mounting holes suits steel frames and concrete pads, and alignment is straightforward on either. A firm, aligned seat under the drive shaft is what keeps these units running quietly.

Start the selection with the shaft diameter and the insert bearing you intend to use; the housing has to be a B22400 match. Look at the sealing as well, since the FH version is meant for areas with moderate dust or moisture. At installation, set the base on a clean, flat surface, tighten the fastening bolts and confirm the shaft lines up with the driven equipment. Grease reaches the insert through the channel in the housing, using the lubricant called for by the application.

Base dimensions, center height and shaft diameter are what allow housings of this family to interchange between makers, provided the insert series and locking type also agree. For a quote, give the complete housing code and, when you have it, the make and code of the bearing it will carry. MR Industrial Accessories LLC will point you to the compatible option.